Anti-collision swing gate access control system debugging steps Analysis: 1, ready to debug Anti-collision swing a wiring diagram, anti-collision swing device 1 set. 2, check the wiring Check the motor wiring according to the wiring diagram and mains connection. Check the power wiring and other wiring of the entire equipment is correct. Confirm after power on debugging! Equipment protection must be reliably grounded, or not allowed to debug; 3, functional debugging 1) This gate is normally bi-directional anti-collision swing gate. External into the credit card signal, the credit card to the signal. 2) When there is no credit card signal, when the pedestrian enters into the alarm, the same time there is no credit card signal, when the pedestrian from entering the alarm. 3) pedestrian swipe: When the pedestrian swipe the direction of the green arrow into the instructions, the gate opens to start the delay, the pedestrian traffic within the set transit time the gate closed, the green arrow turns red prohibited. If overtime pedestrians still do not pass the gate is closed, the green arrow turns red forbidden. 4) Pedestrians pass as if they are too close to the specific time limit is treated as one person. 5) Anti-collision swing switch speed adjustable. See parameter settings. 4, power running Intelligent anti-collision swing gate for the normally closed type anti-collision swing gate after power automatically shut down, power automatically open.